Bowers-group Sylvac D100S Readouts Uživatelský manuál stáhnout pdf (Strana 52)

1.8 REAR PANEL

1.8.1 RS-232-C Input/output

9 pin D-sub female connector (external view):

Pin 1: Charger output 8.5 V/300 mA non-regulated (current limit protection). Output only with charger connected.

Pin 2: RXD = RS-232-C output when Print key or foot pedal (if configured) is pressed, or by remote command.

Pin 3: TXD = RS-232-C input for remote command from computer.

Pin 4: DTR (Data Terminal Ready): not used.

Pin 5: SG = Signal ground.

Pin 6: DSR (Data Set Ready) = not used.

Pin 7.8: Unconnected.

Pin 9: 6 to 7 V/150 mA accumulator output, non-regulated (current limitation).

To configure the RS-232-C transmission parameters, press then (refer to "PRINT key" Section 1.6.14).

1.8.2 RS232 input instrument (OptoRS simplex or duplex)

9 pin D-sub male connector (external view):

Pin 1: Charger output 8.5 V/300 mA.

Pin 2: TXD = RS-232-C input from connected OptoRS instrument.

Pin 3: RXD = RS-232-C output for OptoRS duplex instrument: data request or min/max. mode selection.

Pin 4: DSR: output for data request for OptoRS simplex instrument or positive supply for OptoRS duplex.

Pin 5: SG = Signal ground.

Pin 6: not connected.

Pin 7: CTS (Clear to Send) = positive supply for OptoRS simplex instruments or negative for duplex.

Pin 8: not connected

Pin 9: 6 to 7 V / 150 mA accumulator output.

5 4 3 2 1

9 8 7 6

1 2 3 4 5

6 7 8 9

23 45

678

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 73 74

Žádné komentáře

Bowers-group Sylvac D100S Readouts Uživatelský manuál Strana 52