Bowers-group Sylvac D100S Readouts Uživatelský manuál stáhnout pdf (Strana 58)

1.10 REPLACING THE LITHIUM MODULE

If the following message appears on the screen when the unit is switched on:

This means that the data back-up lithium module is flat (average life 10 years).

It is possible to use unit D100S with a "flat" lithium module, but all parameters

and functions entered by the operator will be lost each time the unit is switched

off.

The module is replaced as follows.

- After obtaining a new lithium module from your Sylvac representative place the unit on a table and remove the 4

retaining screws of the cover.

- Touch a water pipe or other object connected to ground to release any static build-up (the inside of the unit is sen-

sitive to electrostatic discharges).

- Remove yellow cover.

- Remove lithium module with a screwdriver:

- Insert new lithium module, replace cover and replace the 4 cover retaining screws.

- When the unit is switched on again, the memory contents lost message will appear once more.

ERR 3

OUT OF MEMORY

enter one key

eine Taste drücken

presser une touche

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 73 74

Žádné komentáře

Bowers-group Sylvac D100S Readouts Uživatelský manuál Strana 58